LED/UV soak off top gel

nail care material LED soak off gel clear

1. A clean face: use a clean water to wash water

2. Remove dead skin: dead skin softening, pushing up, clean cut off

3. Method one: amid the sponge surface to cast light nail without luster, and then clean a face. Method 2: use adhesive coating on a surface to dry completely.

4. Besmear bottom plastic: to use one of five fingers, after besmear according to light besmear again after another 5 fingers. Glue, first from the tail to refer to thumb besmear according to the order, the first five nails surface covered with plastic, until the fifth with thumb nails began after the bag, bag side in turn from the thumb in order to tail to besmear, finally tail to end as soon as possible after the bag as light. About 2 minutes as the UV lamp, LED lamp about as 30 seconds, manicurist according to different lamp to adjust the time for light.

5. The first layer coating color armour oil plastic: from the tail to refer the four fingers alternate operation, thumb finally separate operation. Start from the tail to order a rubber coating on the oil will nail surface, besmear after the last one of the index finger her nails, begin from index finger to tail to the bag, tail to end as soon as possible after the bag as light, light on besmear according to another one of the hands of the four fingers. About 2 minutes as the UV lamp, LED lamp about as 1 minute, manicurist according to different lamp to adjust the time for light. Single thumb besmear, thumb also need to undertake overlock operation. As far as possible when glue with thin, a oil coated adhesive is too thick as easy to cause the light wrinkle. The edge of the bag operation action quickly as far as possible, overlock operation time more short more good, overlock of the time in a few easy to cause the plastic with a shrinking edge. Rapid bag edge, the lamp can be avoided as soon as possible as a glue the damaging effects of edge may shrink.

6. With the second floor color armour oil plastic: the second and the first layer of the operating methods. Suggestions according to dry in the second after a oil glue, with skimmed type clean wiper gel with a small amount of water, will be a rubber surface oil of the wet glue wipe gently off, such doing can effectively prevent the rubber sealing layer coated with rubber, contraction produce shrinkage after the edge of unhealthy phenomenon.

7. Tu sealing layer: with the operation method and sealing layer with the first layer of the same color armour oil glue, left and right of the four fingers alternate operation, thumb finally separate operation. With TuJia oil rubber, coating layer edge sealing bag is very important also, good package side can make to nail down the long pointed to keep full color, won't appear incomplete nails, pointed the bad phenomena rub off. Try to extend the sealing layer as light of time, this can make to the layer more abiding lustre and tenacity. UV light about 2 to 3 minutes, LED lamp as about 60-90 seconds.

8. Clean the surface of sticky residues seal layer.

9. With oil nutrition, completed.